8510系列拉壓力傳感器

結構緊湊，尺寸小，安裝方便，適用于小而極小的力，機械過載停止

Features
- 量程范圍小，從 0 ... 20 N 到 0 ... 2 MN
- 可測拉力和壓力
- 過載保護可達到量程的5倍
- 小巧的外形設計
- 安裝方便

Product data

型號	8510
量程范圍	0 … 1 N 0 … 2 N 0 … 5 N 0 … 10 N 0 … 20 N
受力方向	壓力和壓力
標準化信號	可選配
信號輸出	1 mV/V
保護等級	IP20
過載保護	Yes
拉盤	No
受力壓頭	No
使用溫度范圍	-20 ... +80 °C
具體特點	量程范圍小，從 0 ... 20 N 到 0 ... 2 MN 可測拉力和壓力過載保護可達到量程的5倍小巧的外形設計安裝方便

Description

The model 8510 bending beam load cell is suitable for measuring small and extremely small applied forces. The mechanical overload protection available for all measuring ranges prevents the sensor from being damaged by excessively high static and quasi-static loads which can occur during measurement and installation.

The sensor can be extended axially, e.g. by a finger, which does not influence the measuring.

Essential application of this sensor include measurement and testing of the following components:

    Switches (limit-, micro- and toggle-switches)
    Buttons
    Contact coupling and contact decoupling forces
    Frictional forces
    Spring characteristics
    Tension of wire and string windings

The sensor element consists of a double bending beam with applied strain gauges.

Changes in the ohmic resistance of the strain gauge fullbridge caused by applied forces are converted into electrical voltages. The precise value (characteristic value) of the output voltage, resulting from the application of a rated force to the sensor, is specified in the accompanying calibration protocol.

The sensor has to be mounted by two screws on the cable side. The opposite side is meant to receive applied forces (loads).

Once the rated stress or strain is exceeded by 20 %, further deflection of the bending beam is prevented by an integrated, mechanical stop. This protects the sensor element against permanent deformation.
Downloads

Data sheet

8510參數資料
EN

Operation manual

8510使用手冊
EN