深圳市思特克氣動液壓有限公司
深圳市思特克氣動液壓有限公司
板牙工具ThreadingToolThreadingToolcanbethreadedmanualmakingL.H.screw,isanessentialtoolforhighpressureTubing.板牙工具可手動制作鋼管的左旋螺紋，是超高壓管件加工的工具
板牙工具 Threading Tool
• Threading Tool can be threaded manual making L.H. screw , is an essential tool for high pressure Tubing.
板牙工具可手動制作鋼管的左旋螺紋，是超高壓管件加工的工具。
• Design of the guide sleeve , ensure the concccentricity of processing.
設計有導向套，保證了加工的同心度。
TT6板牙工具
型號說明 Model description
板牙操作說明 Threading operation instruction
• Claming fixed block of coning tool（horizontal or vertical installation）.
把CT工具上的固定塊固定（水平或者垂直安裝）。
• Loosen the tighten glａnd nut , and remove the handle together.
把旋轉螺母松開和手柄一起拿掉。
• The pipe cone inserts into the chuck outward , and lock the gland（As shown in the following figure）.
松開螺母，把鋼管錐面朝外插進夾頭里面鎖緊螺母（如下圖所示）。
• In the observation hole drops into the cutting oil , to maintain lubricating on blade teeth.
在板牙工具上的觀察孔上滴進切削油，使牙刃上保持潤滑。
• Hold the handle with both hands , the threading hole pressing to trap the cone end , in a counter clockwise rotating forcibly tools , turn back after each turn 1～2 rounds , chip cutting discharge , then turned into , according to the required length of the left-hａnd thread cutting out , finally inversion tools completely out.
雙手握住手柄，把板牙孔壓緊套住管錐端，逆時針用力轉動工具， 每轉動1～2轉就要退轉，使切削屑排出，再進轉，根據所需長度把左旋螺紋切削出來，最后反轉工具*退出，板牙完成。
板牙和錐面尺寸 Threading Size and Cone
倒內圓錐工具 Reseating Tool
• Reseationg tools is used to repair old or damaged valve or equipment connector.
倒內圓錐工具用于維修舊的或是損壞的閥門或是連接件的內孔。
彎管器 Bending Tool
• Applicable to high pressure steel pipe , outer diameter 1/4" , 3/8" , 9/16".
適用于高壓鋼管外徑1/4"、3/8"、9/16"。
您感興趣的產品PRODUCTS YOU ARE INTERESTED IN
儀表網 設計制作，未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
