8740系列DC/DC位移傳感器

• Features

  • 量程范圍從0 … 1 mm 到0 ... 150 mm
  • 非線性度 0.25 % F.S.， 可以選配非線性度 0.1% F.S.
  • 集成放大器，信號輸出 0...5V
  • 可以選配信號輸出為 0...10V 或 4...20mA
  • 不易受到設備不易受振動或沖擊
  • 特別型號定制可參考選配

• Product data

  型號	8739
  量程范圍	0...1mm 0...2mm 0...5mm 0...10mm 0...25mm (不帶復位彈簧)
  信號輸出類型	0...10V 0...5V ±5V 4...20mA 10...0V 5...0V USB
  保護等級
  工作溫度
  激勵供電電壓
  復位彈簧
  具體特征

• Description

  Inductive displacement sensors using the principle of the differential transformer (LVDT) can be used to measure displacement and, indirectly, magnitudes that can be converted into displacements such as force, pressure, strain, torque, vibration and so forth.
  
  Thanks to the high quality of their measurements, their high protection and long service life, these sensors are used in many technologies (industry, research, development, etc.).
  
  Applications include measuring, controlling, regulating and monitoring both slow and fast movements between machine parts, measurements of position and positional changes of components and structural foundations, servo regulators, valve and robot controllers, growth measurements and so on.
  
  Their design is robust - the internal coils and electronics are potted - as a result of which the sensors can easily withstａnd shock and vibration. This makes the sensors also suitable for applications (e.g. in vehicles) and for test installations where they will be subject to many test cycles.
  
  These inductive displacement sensors with integrated electronics incorporate a differential transformer and a carrier frequency measuring amplifier, potted and protected by a stainless steel housing.
  
  The differential transformer consists of one primary winding and two secondary windings; these are arranged symmetrically on either side of the primary winding. The integrated electronics demodulates, filters and amplifies the AC voltage induced in the secondary windings. A rod-shaped core is able to move inside the differential transformer. As an output, the sensor delivers a DC voltage whose magnitude proportionally depends on the position of the moveable core inside the sensor.
  
  Model 8740 incorporates a freely moveable, non-sprung core with two sliding Teflon rings that center the core in the hole through the body of the sensor. At the end of the moving rod is an M2 thread that can be used to couple the core mechanically to the object being measured. Any lateral force acting on the rod should be avoided.
  
  The moveable rod of model 8741 is mounted on ball bearings. A spring holds the tip of the probe against the object being measured. This version is advantageous when it is difficult or entirely impractical to implement a mechanical coupling. Once again, lateral forces will shorten the service life. The measuring side of the sensor is protected against pollution and splash water by a bellows.
  

• Downloads

  Data sheet

  8739參數資料

  EN

Related products

DIGIFORCE® 9307
DIGIFORCE® 9311