額定電壓0.6/1kV銅芯、鋁芯聚氯乙烯絕緣護套(阻燃)電力電纜
Cu-core/Al core PVC insulated and sheathed,flame-retarding power cable at a rated voltage of 0.6/1kv
執行標準
STANDARD IMPLEMENTED
額定電壓0.6/1kV聚氯乙烯絕緣和護套(阻燃)電力電纜GB/T12706.1-2002等效采用IEC60502.2-1997，阻燃型電纜燃燒特性符合GB/T18380.3-2001
The above cable conforms to the GB/T12706.1-2002, which isequal to IEC60502.2-1997, Flame retarding property confor-ms to GB/T18380.3-2001.
使用特性
SERVICE CHARACTERISTICS
電纜導體長期允許工作溫度應不超過70℃,短路時(最長持續時間不超過5S),電纜導體的溫度不超過160℃ 。
敷設電纜時的環境溫度應不低于0℃,敷設時,不受落差限制,維修簡便。
敷設電纜時其最小彎曲半徑應不小于電纜外徑的10倍，鎧裝電纜最小彎曲半徑應不小于電纜的12倍，五芯電纜最小彎曲半徑不小于電纜外徑15倍。
The permitted temperature for long-time operating should notexceed 70℃, and should not exceed 160℃ at a short circuit.(lasting no longer than 5s)
The ambient temp should not be lower than o℃while layingcables.The laying is not limited by the drop height and easy tobe fixed.
The shortest bend radius should not be shorter than ten timesof outer diam of cables for laying; For armored cable , it shouldnotbe shorter than twelve times of outer diam; and for 5-corecable ,it should not be shorter than fifteen times of outer diam.
產品用途
APPLICATION
該產品適用于額定電壓0.6/1kV的線路中,供輸配電能之用(阻燃電纜適用于高層建筑、地鐵、發電站、大型工礦企業等電纜敷設密度大,防火要求嚴格的地方)。
The product applies to the lines of a 0.6/1kv rated voltage.Theproducts is mainly used for electric transmission and transpor-tation in highrise buildings，subways , power stations, entert-ainment places，industrial enterprises and sea pertrol platfor-m etc，where a high intensity of cable laying and a strongability are required.
